
Flood Lights
HILE LED Flood Light
Our highest efficiency flood light, with 170 lm/W and an AC 90 to 305 V input.
- Power
- 50W to 500W
- Efficacy
- 170 lm/W
- Protection
- IP66
- Input voltage
- AC 90 to 305 V
- Surge protection
- 10 kV
- 170 lm/W rated efficacy
- Extra wide AC 90 to 305 V input
- 50W to 500W in one series
HILE, our highest efficiency flood light
HILE is the flagship of our LED flood light range. It is rated at 170 lm/W, the highest figure among our flood series, accepts AC 90 to 305 V and carries 10 kV surge protection (L-N and L+N-PE) on every size. The warranty is 5 years. Six sizes run from 50W to 500W in an IP66 die-cast aluminum housing. Sports grounds, container yards, construction sites and building floodlighting are the typical jobs.
High efficacy pays off on large sites. At 170 lm/W, a 300W HILE gives roughly the same output as a 400W fitting at 130 lm/W. Over a yard with fifty poles, that difference shows up in the energy bill, in the size of the cables and in the generator needed on a construction site.
Wide input from 90 V to 305 V
The AC 90 to 305 V range covers 110 V, 220 V and 277 V supplies with one product. It also gives headroom for grids where voltage swings far from nominal. Many floodlights fail early because the driver sees voltage outside its window night after night. A wide input driver avoids that.
For importers, the wide range means one HILE stock serves customers on different networks.
Choosing a HILE wattage
Calculated output is rated power times 170 lm/W. The quotation gives measured values for your order. The beam is 90° up to 200W and 60° from 300W.
| Wattage | LEDs | Calculated output | Typical use |
|---|---|---|---|
| 50W | 64 | 8,500 lm | Building entrances, small yards |
| 100W | 216 | 17,000 lm | Car parks, warehouse exteriors |
| 200W | 384 | 34,000 lm | Training pitches, container rows |
| 300W | 480 | 51,000 lm | Sports grounds, port areas |
| 400W | 720 | 68,000 lm | Large yards, construction floodlighting |
| 500W | 1,008 | 85,000 lm | Stadium side towers, large open areas |
A rule of thumb for replacing metal halide floodlights: a 1000W metal halide fitting can often be replaced by a 400W to 500W HILE, and a 400W metal halide by a 150W to 200W fitting. Aiming angle and mounting height change the result, so share your site plan before ordering.
HILE among our flood lights
- HILO shares the 170 lm/W engine and the AC 90 to 305 V input in a framed housing, and adds a 150W step.
- MIKA runs at 130 lm/W but adds lens optics and IK08 impact protection.
- KASO costs less at 110 lm/W and covers 30W to 600W.
- GOTO modules go up to 1000W with narrow beams for stadium towers.
Choose HILE when energy cost and output per watt decide the tender.
Installation notes
HILE mounts on its bracket to a wall, pole crossarm or tower frame. For sports and yard lighting, aim each fitting so the beam center lands about two thirds of the way across the area it covers, and avoid pointing the beam above the horizon. That reduces glare for players and neighbors.
Options
HILE comes in 2700K to 6500K. Sports and yard projects mostly use 4000K or 6000K, while facades often use 3000K. We print your logo on the housing and pack in your own box. Every size carries 10 kV surge protection, the level we recommend for exposed poles and lightning-prone regions.
Applications
- Sports grounds
- Ports and container yards
- Construction sites
- Building floodlighting
Specifications
| Power | 50W / 100W / 200W / 300W / 400W / 500W |
|---|---|
| Rated efficacy | 170 lm/W |
| LED chip | SMD 3030 |
| Input voltage | AC 90 to 305 V |
| Ingress protection | IP66 |
| Surge protection | 10 kV (L-N and L+N-PE) |
| Color temperature | 2700K to 6500K |
| Color rendering | Ra ≥ 80 |
| Beam angle | 60° / 90° |
| Power factor | > 0.95 |
| Housing | Die-cast aluminum housing, PC lens |
| Warranty | 5 years |
10 kV surge upgrade
The values here are our standard configuration. Every series can be built with 10 kV surge protection for exposed poles and lightning-prone regions, at a small extra cost.
Packing and shipping
Our quotation lists the carton size, quantity per carton and gross weight of each item. We prepare the packing list for your forwarder.
HILE Models
| Power | LEDs | Luminous flux* | Surge (L-N) | Size |
|---|---|---|---|---|
| 50W | 64 pcs | 8,500 lm | 10 kV | 256 × 195 × 50 mm |
| 100W | 216 pcs | 17,000 lm | 10 kV | 315 × 240 × 60 mm |
| 200W | 384 pcs | 34,000 lm | 10 kV | 380 × 290 × 60 mm |
| 300W | 480 pcs | 51,000 lm | 10 kV | 420 × 350 × 60 mm |
| 400W | 720 pcs | 68,000 lm | 10 kV | 492 × 410 × 60 mm |
| 500W | 1008 pcs | 85,000 lm | 10 kV | 570 × 475 × 60 mm |
*Calculated as rated power × rated efficacy. Measured values per order are confirmed in the quotation.
Compare HILE With Similar Series
| Series | Power | Efficacy | Input voltage | Protection | Surge (standard) | Warranty |
|---|---|---|---|---|---|---|
| HILE | 50W to 500W | 170 lm/W | AC 90 to 305 V | IP66 | 10 kV | 5 years |
| HILO | 50W to 500W | 170 lm/W | AC 90 to 305 V | IP66 | 10 kV | 5 years |
| KASO | 30W to 600W | 110 lm/W | AC 180 to 265 V | IP66 | 4 to 6 kV | 3 years |
| MIKA | 30W to 300W | 130 lm/W | AC 85 to 265 V | IP66 | 6 kV | 3 years |
| AMOS | 30W to 400W | 110 lm/W | AC 180 to 265 V | IP66 | 4 to 6 kV | 3 years |
| KALS | 10W to 400W | 110 lm/W | AC 180 to 265 V | IP66 | 4 to 6 kV | 3 years |
| VENS | 10W to 200W | 90 lm/W | AC 180 to 265 V | IP66 | 4 to 6 kV | 3 years |
| HITO | 30W to 200W | On request | AC 180 to 265 V | IP66 | On request | 3 years |
| FINO | 30W to 200W | On request | AC 185 to 265 V | IP66 | On request | On request |
| KASO RGB | 30W to 100W | On request | AC 85 to 265 V | IP66 | On request | 3 years |
HILE FAQ
Is 170 lm/W the efficacy of the whole fitting?
Yes. 170 lm/W is the rated efficacy of the HILE fitting, not only of the LED chip. Lumen values on this page are calculated from that rating, and the quotation gives measured values for your order.
Which HILE replaces a 1000W metal halide floodlight?
In many layouts the 400W or 500W HILE replaces a 1000W metal halide fitting. Mounting height and aiming decide the final size.
Can HILE run on 277 V?
Yes. HILE accepts AC 90 to 305 V, which covers 277 V supplies used in some commercial and industrial sites.
Is HILE suitable for sports grounds?
Yes. Training pitches and community grounds often use the 200W to 500W HILE on poles. For tall stadium towers with narrow beam requirements, GOTO modules are the better match.
Related Products

HILO LED Flood Light
170 lm/W flood light from 50W to 500W in a framed die-cast housing.
- 50W to 500W
- 170 lm/W
- IP66
- Surge 10 kV

KASO LED Flood Light
One family from 30W to 600W, the easiest series for a distributor to stock.
- 30W to 600W
- 110 lm/W
- IP66
- Surge 4 to 6 kV

MIKA LED Flood Light
Lens optic flood light with IK08 impact rating and a wide AC 85 to 265 V input.
- 30W to 300W
- 130 lm/W
- IP66
- Surge 6 kV
Get a Quote for HILE
Send us your requirement. We reply with prices, specifications and packing data.
- Chat with sales