
LED Street Lights
LETO LED Street Light
Sodium lamp replacement from 30W to 300W with a replaceable surge protector.
- Power
- 30W to 300W
- Efficacy
- 120 lm/W
- Protection
- IP66 · IK08
- Input voltage
- AC 85 to 265 V
- Surge protection
- 6 kV
- Replaceable 10 kV / 10 kA SPD option
- IP66 and IK08 rated
- Wide AC 85 to 265 V input
LETO for sodium lamp replacement
LETO is designed for one-to-one replacement of 50W to 250W high pressure sodium street lights. Retrofit tenders want a fitting that goes onto the existing arm, survives the same lightning and vandalism the old one did, and lasts longer. LETO answers each of those with a side-entry bracket, IK08 impact rating, 6 kV standard surge protection and an optional replaceable 10 kV / 10 kA SPD.
The series runs from 30W to 300W in six steps at a rated 120 lm/W, accepts AC 85 to 265 V through an independent driver and is sealed to IP66. The beam is 140° by 70°, shaped for road surfaces.
A surge protector you can replace
On most street lights the surge protector sits on the driver board. When a strike exceeds its rating, the installer replaces the whole fitting. LETO puts the optional 10 kV / 10 kA SPD in a separate module. After a strike, the crew swaps the module on the pole and the light keeps working. In regions with frequent storms, that turns a fitting replacement into a small spare part.
Every LETO carries 6 kV protection as standard. Order the 10 kV / 10 kA module for long overhead lines, open highways and coastal roads.
Impact and weather
IK08 means the housing withstands a 5 joule impact, roughly a 1.7 kg mass dropped from 300 mm. On low poles near schools, markets and bus stops, that matters. IP66 keeps out dust and water jets from any angle.
Retrofit sizing
Calculated output is rated power times 120 lm/W. The quotation gives measured values for your order.
| LETO | Calculated output | Typically replaces |
|---|---|---|
| 30W | 3,600 lm | 50W sodium |
| 50W | 6,000 lm | 70W to 100W sodium |
| 100W | 12,000 lm | 150W sodium |
| 150W | 18,000 lm | 250W sodium |
| 200W | 24,000 lm | 250W sodium on wide roads |
| 300W | 36,000 lm | 400W sodium |
These pairings are typical starting points for retrofit work. The old fitting's optic, the pole spacing and the target lux level can shift the choice, so we check against your survey data.
Mounting
The side-entry bracket fits Ø50 to 60 mm spigots. Retrofit crews often find both sizes on the same network, and LETO takes either without adapters.
Voltage
AC 85 to 265 V input means LETO keeps working on networks where voltage drops in the evening peak. It also covers 110 V supplies.
LETO in our street range
- LEGO is cheaper at 110 lm/W and offers a NEMA socket, but has no IK rating, no replaceable SPD and a narrower AC 180 to 265 V input.
- LOLA runs at 150 lm/W for new-build residential roads, and LOMA offers a slim body at 110 lm/W.
- KILA goes up to 400W for main roads.
Choose LETO when the job is a retrofit, the site sees lightning, or the poles are within reach of vandals.
Options
LETO comes in 2700K to 6500K, and accepts your logo and packaging. If a tender scores efficacy, ask for a higher efficacy configuration and we quote it separately.
Applications
- Sodium lamp retrofit
- Main and secondary roads
- Roundabouts
- Car parks and industrial areas
Specifications
| Power | 30W / 50W / 100W / 150W / 200W / 300W |
|---|---|
| Rated efficacy | 120 lm/W |
| LED chip | SMD 2835 |
| Input voltage | AC 85 to 265 V |
| Ingress protection | IP66 |
| Impact protection | IK08 |
| Surge protection | 6 kV; 10 kV / 10 kA replaceable SPD module optional |
| Color temperature | 2700K to 6500K |
| Color rendering | Ra ≥ 80 |
| Beam angle | 140° × 70° |
| Power factor | > 0.95 |
| Housing | Die-cast aluminum housing, PC lens |
| Mounting | Side-entry, Ø50 to 60 mm |
| Warranty | 3 years |
10 kV surge upgrade
The values here are our standard configuration. Every series can be built with 10 kV surge protection for exposed poles and lightning-prone regions, at a small extra cost.
Packing and shipping
Our quotation lists the carton size, quantity per carton and gross weight of each item. We prepare the packing list for your forwarder.
LETO Models
| Power | LEDs | Luminous flux* | Surge (L-N) | Size |
|---|---|---|---|---|
| 30W | 36 pcs | 3,600 lm | 6 kV | 375 × 172 × 65 mm (Ø50 pole) |
| 50W | 60 pcs | 6,000 lm | 6 kV | 420 × 200 × 70 mm (Ø50 pole) |
| 100W | 120 pcs | 12,000 lm | 6 kV | 490 × 210 × 80 mm (Ø60 pole) |
| 150W | 150 pcs | 18,000 lm | 6 kV | 540 × 225 × 80 mm (Ø60 pole) |
| 200W | 200 pcs | 24,000 lm | 6 kV | 595 × 230 × 80 mm (Ø60 pole) |
| 300W | 360 pcs | 36,000 lm | 6 kV | 745 × 300 × 80 mm (Ø60 pole) |
*Calculated as rated power × rated efficacy. Measured values per order are confirmed in the quotation.
Compare LETO With Similar Series
| Series | Power | Efficacy | Input voltage | Protection | Surge (standard) | Warranty |
|---|---|---|---|---|---|---|
| LOLA | 30W to 150W | 150 lm/W | AC 185 to 265 V | IP66 | 6 kV | 3 years |
| KILA | 100W to 400W | 150 lm/W | AC 85 to 265 V | IP66 | On request | On request |
| HILO | 100W to 300W | 150 lm/W | AC 90 to 305 V | IP66 | 10 kV | 5 years |
| LOMA | 50W to 200W | 110 lm/W | AC 185 to 265 V | IP66 | 6 kV | 3 years |
| LEGO | 50W to 200W | 110 lm/W | AC 180 to 265 V | IP66 | 6 kV | 3 years |
| LETO | 30W to 300W | 120 lm/W | AC 85 to 265 V | IP66 | 6 kV | 3 years |
| LOTA | 100W to 300W | 110 lm/W | AC 85 to 265 V | IP66 | 6 kV | 3 years |
LETO FAQ
How does the replaceable SPD on LETO work?
The optional 10 kV / 10 kA surge protector sits in its own module. After a lightning strike, the maintenance crew replaces that module on the pole. The LED board and driver stay in service.
Which LETO replaces a 250W sodium street light?
The 150W LETO usually replaces a 250W high pressure sodium lamp. On wide roads with long spacing the 200W is safer. Send your survey and we confirm.
What spigot sizes does LETO fit?
The side-entry bracket fits Ø50 to 60 mm spigots, which covers most existing sodium lamp arms.
What does IK08 mean for a street light?
IK08 means the housing survives a 5 joule impact. It protects fittings on low poles from thrown stones and accidental knocks.
Related Products

LOLA LED Street Light
Compact 150 lm/W street light for residential roads and village lanes, 30W to 150W.
- 30W to 150W
- 150 lm/W
- IP66
- Surge 6 kV

KILA LED Street Light
High power street light up to 400W with a wide 85 to 265 V input for unstable grids.
- 100W to 400W
- 150 lm/W
- IP66

HILO LED Street Light
Main road street light, 100W to 300W, with a Ø65 mm mount and wide input voltage.
- 100W to 300W
- 150 lm/W
- IP66
- Surge 10 kV
Get a Quote for LETO
Send us your requirement. We reply with prices, specifications and packing data.
- Chat with sales